You are familiar with electronics and want to test our various pumps without much effort? Then this is the right set for you.
With the electronics mp6-EVA – it gets its power from the USB interface of your PC – you can set the voltage and frequency directly on the board.
This is possible via the different jumpers.
Thus the mp6-EVA board is the optimal choice for first tests.
You can connect the mp6-EVA directly to the pump via the built-in Molex connector.
Hose (mp-t) and hose connector (mp-hc) are sufficiently included in the set.
To help you find out which micro pump is the right one for your application, we offer different pump types in the sets.
This set contains two mp6-liq micropumps with which you can achieve our guaranteed standard values when pumping water or air.
If you need a higher suction pressure, we recommend – also for liquid applications – the mp6-gas: It is specially measured for gas and is a special “performer” in this field.
The set also includes two mp6-gas+, which we recommend especially for applications with high pressure in the gas range.
Technical data (basic)
mp6-basic evaluation-set containing:
Piezoelectric double diaphragm pump (2x mp6-liq, 2x mp6-gas, 2x mp6-gas+)
- material in fluid contact: Poly Phenylene Sulphone (PPSU)
dimensions: 30 x 15 x 3.8 mm³ without fluid connectors
fluid connectors: barbed tube connector; outer diameter 1.9 mm
electrical connector: flexible printed circuit
controlable volume range: 8 µl/min – 8000 µl/min
volume flow: typ. 8 ml/min
back pressure: typ. 500 mbar
(data taken with DI water, settings of the extended controller: 100 Hz, 250 V, SRS signal).
volume flow: typ. 20ml/min
back pressure: typ. 100 mbar
(data taken with air, settings of the extended controller: 300 Hz, 250 V, SRS signal).
volume flow: typ. 20 ml/min
back pressure: typ. 150 mbar
(data taken with air, settings of the extended controller: 300 Hz, 250 V, SRS signal).Priming characteristic: suction pressure < 10 mbar; DI water; settings mp-x: 100 Hz, 250 V, SRS; the maximum flowrate is reached after a couple of minutes of operation.
Evaluationboard for controller mp6-OEM
The board includes one controller mp6-OEM
Dimensions approx. 30 x 65 x 20 mm³
Power supply externally or via USB
Amplitude and frequency can be adjusted by external circuitry.
- mp-t ID1.3
Tygon® Tubing for micropump
Inner diameter 1.3 mm
- Mini-USB Kabel
- Software and driver
- Micro Hose Clamp mp-hc
Leakproof tube connection that fits perfectly on the tubing mp-t (1.3mm id; 3mm od) over the mp6-series barbs.
The clips are easy to mount.
Full-plastic (PPSU) and reusable
Customs tariff code
You can find more technical data in the data sheet or in the download area on our homepage
All needed documentations, manuals, software are available on our homepage in the download section