Description
mp6-lab! set
With the laboratory electronic mp-x you act comfortably in laboratory applications, but also for intensive test series or if you are not so familiar with the secrets of electronics.
With this electronic you can easily adjust frequency, amplitude and signal shape at the knobs and toggle switches to achieve the desired change of flow or pressure values.
With this set you will receive a USB cable for connection to your PC and a power cable for the power supply as well as an mp6-con cable to connect the pump.
The matching hose (mp-t) and hose clamps (mp-hc) are also included.
To help you find out which micropump is right for your application, we offer different types of pumps in the sets.
In this set are two mp6-liq micropumps with which you can achieve our guaranteed standard values when pumping water or even air.
If you need a higher suction pressure we recommend – also for liquid applications – the mp6 gas: It is specially measured for gas and is a special “performer” in this field.
The set also contains two mp6-gas+, which we recommend especially for applications with high pressure in the gas range.
Technical data (basic)
mp6-lab! evaluation-set containing:
Piezoelectric double diaphragm pump (2x mp6-liq, 2x mp6-gas, 2x mp6-gas+)
- material in fluid contact: Poly Phenylene Sulphone (PPSU)
dimensions: 30 x 15 x 3.8 mm³ without fluid connectors
fluid connectors: barbed tube connector; outer diameter 1.9 mm
electrical connector: flexible printed circuit
- mp6-liq
typical performance:
controlable volume range: 8 µl/min – 10000 µl/min
volume flow: typ. 8 ml/min
back pressure: typ. 500 mbar
(data taken with DI water, settings of the extended controller: 100 Hz, 250 V, SRS signal).
- mp6-gas
typical performance:
volume flow: typ. 20ml/min
back pressure: typ. 100 mbar
(data taken with air, settings of the extended controller: 300 Hz, 250 V, SRS signal).
- mp6-gas+
typical performance:
volume flow: typ. 20 ml/min
back pressure: typ. 150 mbar
(data taken with air, settings of the extended controller: 300 Hz, 250 V, SRS signal).Priming characteristic: suction pressure < 10 mbar; DI water; settings mp-x: 100 Hz, 250 V, SRS; the maximum flowrate is reached after a couple of minutes of operation.
- mp-x controller
microcontroller-driven electronics:
waveform, frequency and amplitude can be changed separately,
connector for one mp6-series micropump,
usb interface includin driver software,
including power plug and manual.
- mp-t ID1.3
Tygon® Tubing for micropump
Inner diameter 1.3 mm
- Mini-USB Kabel
- Software and driver
- Micro Hose Clamp mp-hc
Leakproof tube connection that fits perfectly on the tubing mp-t (1.3mm id; 3mm od) over the mp6-series barbs.
The clips are easy to mount.
Full-plastic (PPSU) and reusable
Customs tariff code
mp-x 85432000
mp6 84135040
mp-t 39173200
mp6-mol 85369010
mp-hc 39174000
You can find more technical data in the data sheet or in the download area on our homepage
Datasheets
All needed documentations, manuals, software are available on our homepage in the download section
